Category: spray type deaerator

How does deaerator work?

Deaerators can be horizontal or vertically cylindrical in shape. The spray type deaerator contains its deaeration section and a boiler feedwater storage tank. This cylindrically shaped deaerator has a preheating section as well. Low pressure steam is entering the deaerator through what is known as a sparger. The steam that enters the cylindrical vessel will then transfer to its bottom. Boiler feedwater sprays to a section where it will be preheated by steam rising from the sparger.

spray type deaerator

A feed water spray nozzle is required to heat boiler feed water, enabling the water to reach its saturation temperature. This is made possible through the use of a pre-heating section. The saturation temperature is required to facilitate the stripping out of all dissolved gases during the deaeration processes. Pre heated water is allowed to flow into the deaeration section. After this entry is made, the water is deaerated by the steam that rises through the deaerator’s sparger system.

Gases that leave the water, do so through a vent that is located at the top of the deaerating machine. All deaerated boiler feed water gets pumped to the bottom of the deaerator. The water goes right down to the machine’s steam generating boiler system. Readers here who wish to consult more detailed explanations are more than welcome to do so. In fact, this recommended, particularly if you have designs on a new industrial endeavor. You may well have good use for a deaerator inventory on your factory floor.

Words may be all this short article has, so readers here are also able to consult clear and visual demonstrations, in a step by step manner, of how the deaerating processes unfold. Further, detailed technical specifications are there for those who wish to invest time learning of them.